What is the Cause of the Overall Vibration of the Slurry Pump
As a Slurry Pump Manufacturers , share with you. 1. The bearing assembly is unreasonable. Reassemble the bearing and axle, or replace the bearing. 2, the lubrication is not good. Excessive, too few impurities will lead to short bearing life, the bearing should be taken out and cleaned before use. 3. There is friction in the submerged slurry pump or the impeller is out of balance. The friction should be eliminated or the impeller should be replaced with a new one. 4. The motor shaft and the pump shaft are asymmetrical or not parallel. The motor shaft or pump shaft should be adjusted. If the shaft is deformed or bent, replace the shaft directly. Horizontal Slurry Pumps As the use time of the submerged slurry pump increases, the loss of the submerged slurry pump will increase. In order not to affect the work efficiency, the energy loss of the submerged slurry pump needs to be tested on a regular basis, so how to detect it? 1. The gap of the seal ring is increased According to...